It is an ink of watery base appropriate for the stamping for corrosion to color with concentrated pigments on colored funds with coloring corrodible has more than enough celluloses fibers and mixed fabrics with polyester. It allows the impression wet on wet, in cloths of dark colors, this ink corroded away the coloring of the fabric and overprinted the elected color in a single step.

Very soft tact.
Very good solidity to the laundry.
Brilliant colours on dark funds
Excellent definition

Cotton.
Cotton / mix with synthetic fibers (until 30%).

This ink should be cured to a temperature of 150°C during 3 minutes

Mesh: 43 to 72 threads/ cm monofilament. Photo emulsion: It is recommended to use resistant direct emulsions to the water. Squeegee (spatula): 65 to 75 shore.
For the impression it should mix: Corrosive base CM 86%
Corrosive powder CM 10%
Pigment concentrated 4%
100%
This paste can stay in a container closed by 72 hours, approximately.

All the elements used in the impression should be washed immediately with water after being used, if it was necessary clean the mesh with Agent of Cleaning CM and rinse with abundant water.

The Corrosive Base can be pigmented with watery dispersions of pigments CM with the appropriate selection, since all the pigments are not capable for the corrosion, using until 5%. The mixture should be uniform.
Make rehearsals to check if the product adapts to its necessities.

Warning:
This technical information is orientative only. Color Mixing Argentina SA or any subsidiary or related company assumes no liability or responsability for any unproper or unauthorized use of any of our products. It is strongly recommended to test the products prior to use in order to evaluate your satisfaction.