It is an adhesive type Hot-Melt (insoluble in water) in powdered used to give bigger adherence to the Plastisol transfers, especially when they are transferred on polyamide, polyester or other synthetic fibers.

This Co polyamide can also be used to increase the solidity to the laundry in the transfers with foil (polyester film) and flock.

If the size of the particle of the co polyamide is fine it can be incorporated directly to the Plastisol ink, in this case use meshes from 24 to 31 threads/cm monofilament.

When the size of particle of the co polyamide is thick it should be added sprinkling on the humid Plastisol, moving away the rest before being sub-cured.

If it is added to the Plastisol directly to make it in a percentage from the 10 to 20% with regard to the weight of ink, the percentage will depend on the solidity that we want to achieve.

The use of the co polyamide can give bigger hardness to the transfer.
This co polyamide has a coalition point of around 135°C, for this reason when we transfer we can make it to a temperature more lower than the transference temperature that it is approximately from 185°C to 195°C.

Warning:
This technical information is orientative only. Color Mixing Argentina SA or any subsidiary or related company assumes no liability or responsability for any unproper or unauthorized use of any of our products. It is strongly recommended to test the products prior to use in order to evaluate your satisfaction.