They are white Plastisol inks formulated for the impression of dark fabrics of cotton, cotton / mix and some synthetic fibers. These inks can also be used on clear funds, reducing the color with Reducer 9070 or 9080.
They are formulated to print in wet direct form on wet and for the transfers production.
They can be printed in form manual or automatic, these Plastisoles are manufactured with the most advanced technology what confers them a high opacity, good effect optic, low temperature of cured and easiness in the impression process.
These inks are Tixothropics, for this characteristic, they seem to have a lot of apparent viscosity that decreases in presence of agitation, facilitating the impression, allowing to obtain an excellent resolution and a perfect definition with meshes of different quantity of threads.

Excellent opacity
It allows the impression of fine details with very good definition
Soft tact
Express drying in the flash
Good optic effect
Good solidity.
High concentration of pigment.

It cures at 145°-165° C, the time depends on the oven type and the thickness of the printed ink. It can be treated with ovens to gas, infrared and infrared for convection, the oven type to use and the thickness of the impression modifies the time of cured, it is for this reason that is recommended to make previous rehearsals to the production to adjust the temperature and appropriate times to each impression. Later on to make the rehearsals of cured necessary.
In the transfers production the ink will be gelled (semi cured)a temperature from 90°C to 110°C.

Mesh: 34 to 54 threads/cm monofilament polyester discharge tension, low elongation, for the direct impression of dark fabrics without white base.
From 62 to 80 threads/cm for the direct impression of clear fabrics and means.
From 24 to 43 threads/cm for opaque transfers.
Photo emulsions: use direct emulsions or capillary film, resistant Diazo to the solvents, Diazo / photopolymer or photopolymer.
Squeegee(spatula): Polyurethane 65 - 80 shore.
Tension of the meshes: no under 23 newtons,

All the elements used in the impression can be cleaned with our line of Remover of Ink G&B, they are ecological, biodegradable, not toxic and they are rinsed with cold water.

Soft base: You can use it to reduce the viscosity of the inks and to give him tact but soft.
9050,9070,9080Transparent base: they are transparent and semi-transparent Bases that are used to reduce the color and to stretch the inks.
Co polyamide: additive to be used when synthetic fibers of difficult anchorage are printed. Add to the ink between 2% and 5%.

Warning:
This technical information is orientative only. Color Mixing Argentina SA or any subsidiary or related company assumes no liability or responsability for any unproper or unauthorized use of any of our products. It is strongly recommended to test the products prior to use in order to evaluate your satisfaction.