They are Covering Plastisol inks formulated for the impression of dark fabrics of cotton, cotton / mix and some synthetic fibers, without necessity of applying a white base. These inks can also be used on clear funds, reducing the color with a part of ink and three parts of Reducer 9070 or 9080.
They are formulated to print in wet direct form on wet and for the transfers production.
These Plastisoles are manufactured with the most advanced technology what confers them a high opacity, low temperature of cured and easiness in the impression process.
With our Guide of Formulation, each color is expressed in percentage by weight for their later mixture, what will allow us to obtain more than 1000 colors.
These inks are Tixothropics, for this characteristic, they seem to have a lot of apparent viscosity that decreases in presence of agitation, facilitating the impression, allowing to obtain an excellent resolution and a perfect definition with meshes of different quantity of threads.

Excellent opacity
It allows the impression of fine details with very good definition
Soft tact
Express drying in the flash
Brilliant Colours
Good solidity.
High concentration of pigments

It cures 145°-165° C, the time depends on the oven type and the thickness of the printed ink. It can be treated with ovens to gas, infrared and infrared for convection, the oven type to use and the thickness of the impression modifies the time of cured, it is for this reason that is recommended to make previous rehearsals to the production to adjust the temperature and appropriate times to each impression. Later on to make the rehearsals of cured necessary.
In the transfers production the ink will be gelled (semi cured) a temperature form 90°C to 110°C.

Mesh: from 34 to 54 threads/cm monofilament polyester of high tension, low elongation, for the direct impression of dark fabrics without white base.
From 62 to 100 threads/cm for the direct impression of clear fabrics and means.
From 24 to 43 threads/cm for opaque transfers.
Photo emulsions: use direct emulsions or capillary film, resistant Diazo to the solvents, Diazo / photopolymer or photopolymer.
Squeegee(spatula): Polyurethane 65 - 80 shore.
Tension of the meshes suggested: nor under 23 newtons

All the elements used in the impression can be cleaned with our line of Remover of Ink G&B, they are ecological, biodegradable, not toxic and they are rinsed with cold water.

Soft base: You can use it to reduce the viscosity of the inks and to give them softer tact.
Transparent Base 9050,9070,9080: they are transparent and semi-transparent bases that are used to reduce the color and to stretch the inks.
Co polyamide: additive to be used when synthetic fibers of difficult anchorage are printed. Add to the ink between 2% and 5%.

Warning:
This technical information is orientative only. Color Mixing Argentina SA or any subsidiary or related company assumes no liability or responsability for any unproper or unauthorized use of any of our products. It is strongly recommended to test the products prior to use in order to evaluate your satisfaction.