It is an ink of watery base for the impression on paper of sublimation transfers, these can be transferred later on by heat to different synthetic fabrics.

Excellent tact
Very good impression qualities
Good definition of fine details
Excellent solidity to the laundry
Good relationship cost-benefit
Good adhesion between the paper and the substrate.

Polyester
Polyamide
Acrylic
Recovered Metals

Mesh: 100 to 120 threads/cm Monofilament of Polyester
Photo emulsion: Resistant Diazo to the water, Diazo / photopolymer.
Squeegee(spatula): 70 to 80 Shore polyurethane

This ink dries to the air in approximately from 15 to 20 minutes depending on the temperature and humidity ambient.
These inks can dry off with hot air to temperatures nor superiors to 50°C.

The use of a not recovered paper is recommended, without breaks and with a surface very equal and not too absorbent couple. It is convenient that it is made of long fiber to assure a good stability, in the case of having recovering it will be very slight to allow certain penetration of the ink.
The recommended weight is from 120 to 150 grams.

You can transfer with scheme industrial or domestic, keeping in mind that it is fundamental to be able to control the temperature, the time and the pressure. The calefaction plates should have a very even surface because the imperfections that these they present, they will be reflected in the transfer.
It is recommended to make previous rehearsals on the different fibers to transfer, until finding the time and the good temperature for that fiber, because the yield of the ink can change with the different fabrics.

Polyester	210 - 220 ºC	From 30 to 40 Sec.
Polyamide	185 - 195 ºC	From 30 to 40 Sec.
Acrylic	180 - 190 ºC	From 25 to 35 Sec.

All the elements used in the impression can clean with our Removers of Inks G&B.
They are biodegradable, ecological, of low toxicity and soluble in water.

Retardant: If you want to slow the drying of the ink in the wing add from 3 to 5% in low agitation.
Thickening substance: You can add from 0,2 to 0,5% to increase the viscosity.

Warning:
This technical information is orientative only. Color Mixing Argentina SA or any subsidiary or related company assumes no liability or responsability for any unproper or unauthorized use of any of our products. It is strongly recommended to test the products prior to use in order to evaluate your satisfaction.