They are inks of watery base for the impression of sublimation transfers. After printed the paper, it can be transferred on the cloth of synthetic fiber, with a thermo transference iron that possesses good pressure and temperature.

Excellent tact
Very good impression characteristics and definition
Excellent solidity to the laundry
It allows to decorate materials that cannot be printed for direct impression
Quick drying, for hot air or to the air

Polyester
Polyamide (nylon 6, nylon 6,6)
Lycra
Acrylic
PVC
Anodizing Aluminum
Recovered metals.

Mesh: 100 to 120 threads/cm. Monofilament of Polyester
Photo emulsion: It is recommended to use resistant Direct emulsions to the water or Diazo / Photopolymer.
Squeegee(spatulas): 75 - 80 Shore of Polyurethane

The dry ink to the tact is in approximately from 10 to 20 minutes, depending on the temperature and ambient humidity.
These inks can dry off with hot air with a temperature nor superior to 50°C.

The election of the paper is extremely important because it should allow a good detachment of the ink to obtain a transfers of good quality. The paper uses should have a surface more possible equal, free of powders, breaks and defects, it should be sufficiently strong as to prevent breaks and maintain its characteristics when being exposed to the transfer temperatures. It is recommended to use a paper of long fiber of having recovering it will be the softest thing possible so that it allows certain penetration of the ink because if the penetration is excessive this it can harm the transfer, retaining too much ink in the paper giving opaque colors with little brightness and intensity. The recommended weight is from 120 to 150 grams /cm.

You can transfer with your industrial or domestic machinery always keeping in mind that it is fundamental to be able to control the temperature, time and pressure. The calefaction plates should be similar even possible because the imperfections that these present will be reflected in the transference. The transference of these inks on cotton fabrics or natural fibers are bad, they can be used alone in mixed fabrics where the percentage of synthetic fiber prevails. The transference temperature is from 180 to 225 °C and the time of exhibition oscillates between 25 and 60 seconds.
It is recommended to make previous rehearsals with the different fibers until finding the time and the good temperature for the obtaining of intense and brilliant colors. It is convenient to transfer to a pressure from 0,40 to 0.50 Kg/cm2.

Triacetate	185 -195 °C	25-35 sec.
Polyamide	185 -195 °C	25-35 sec.
Acrylic	180 -190 °C	25-35 sec.
Polyester	210-225 °C	30-45 sec..
PVC	130-150°C	45-60 sec.
Lycra	185-195 °C	25-35 sec.

The SUBLITEX inks can be mixed to each other to achieve a very wide range of colors. When you want to obtain colors of smaller intensity, we recommend to use SR/A Sublitex Reducer (the addition of the same one won't modify the properties of the ink).

All the elements used in the impression should be washed immediately with water. If it is difficult to take out the remains of ink from the mesh it is recommended to use our G&B Removers of Ink and rinse with abundant water.

Retardant: If you want to slow the drying of the ink in the wing, add from 3 to 5% in low agitation.
Thickening Substance: You can add from 0,2 to 0,5% to increase the viscosity.

Warning:
This technical information is orientative only. Color Mixing Argentina SA or any subsidiary or related company assumes no liability or responsability for any unproper or unauthorized use of any of our products. It is strongly recommended to test the products prior to use in order to evaluate your satisfaction.